Enjoy free first class shipping on US orders of $75 or more! No coupon necessary.

Hello, Honey Bee friends! Today I’m sharing my card using the beautiful Lovely Layers: Tulips Honey Cuts and I added a bow that has foiling on it!! I had been wondering if the Small Card Hot Foil Plates would work on materials other than card stock, and much to my delight, they do! I tried out a few different types of ribbon and found I got the best results on the smooth satin type ribbon. I have some photos below to go along with my tutorial for the process.

First I die cut the Lovely Layers: Tulips from some coral, yellow, and green card stock. I added some shading to the pieces with Distress Oxide ink and Detail Blender Brushes. I used Mustard Seed, Squeezed Lemonade, Mowed Lawn, and Rustic Wilderness. I used a coral ink from my stash for the shading of the coral card stock pieces. I used pieces of foam strips between all of the layers for extra dimension. If you need help with the layers, check out this layering guide:

Before I adhered the leaves and stems to the assembled flowers, I spritzed a bit of white ink spray onto the flowers and set them aside to dry. I die cut some beautiful paper from the Modern Spring paper pad with the largest Sweet Stacks: Rectangles and adhered it to an A2 card base. Then I added a frame I die cut from white card stock where I taped together the two largest A2 Double Stitched Frames dies. I used Bee Creative glue to adhere the frame, tulips, stems and leaves.

As I mentioned above, I used the Small Card Hot Foil plates to experiment foiling on various types of ribbon. I wanted to foil on the bias tape type ribbon as that’s what I have most of. The looser weave of that ribbon just didn’t produce a very smooth foiling though. The tight weave of this satin ribbon is what has worked best for me. I didn’t want to have to guess where to do my foiling, and then tie the bow, so I tied the bow first. These next photos show how I foiled it.

First, with the bow right side up, I laid down the gold foil (shiny side up) and then placed the sentiments from the Small Card Hot Foil Plates set face down onto the foil. I used small pieces of removable tape to hold it all in place.

You need the tape, because now you will turn it over so the plates are touching the heating plate of your machine. (If the ribbon is on the bottom, the plates will not get hot enough–ask me how I know!! LOL!) Following the directions for your machine, let the plates heat for the required amount of time. Leave the tied portion of the bow off the edge as you see below.

When the heating is finished, add the shims required for your machine, and run it through your die cutting machine with the tie bow hanging out. Like this:

I was SO thrilled that this worked! I think it adds such a unique touch to a project!

I trimmed the edges of the bow into a fishtail shape and adhered it with a glue dot. There are so many sentiments in the Small Card Hot Foil Plates set that provide lots of different options, depending on the width of your ribbon.

Oh, one last thing. In the photos you may have noticed that, yep, I foiled my plates! Evidently, just about everyone does that at some point, but good news: it does not affect the plates at all! You can remove the foil, but I just went ahead and used them and there’s no difference in the results!

Foiling on ribbon? Yes, please!! This was lots of fun and has my wheels turning wondering what else can be foiled? I hope you’ve enjoyed my process and have found some inspiration too! Thank you so much for stopping by!

Share this post
2 comments

2 responses to “Lovely Layers: Tulips & Using Hot Foil Plates on Ribbon”

  1. AdventuresWithCarissa says:

    Foiling on Ribbon that’s Incredible Carol!

Honey Bee Stamps